26699 Members
90 Forums
119162 Topics
533116 Posts
Max Online: 479 @ 03/26/08 04:18 PM
|
|
|
Lost your password? Can't remember your username? Having registration problems? Answers to many of these problems can be
FOUND HERE!
|
|
|
#123384 - 09/18/02 04:43 AM
side light
|
Anonymous
Unregistered
|
I need to know how to replace the bulb on the rear drivers side running light. From the outside or inside?
|
|
Top
|
|
|
|
#123385 - 09/18/02 11:45 AM
Re: side light
|
Anonymous
Unregistered
|
If you are talking about the small light on the drivers side rear that is part of the bumper, it removes from the rear side of the bumper.
|
|
Top
|
|
|
|
|
#123386 - 09/18/02 06:38 PM
Re: side light
|
Anonymous
Unregistered
|
The side marker lamp, rear. On page 8L-4 of the service manual it shows pulling the molding away from the bumper fascia. I attempted to pull on it but was afraid I would break something. It looks like it is held in by a snap. If this is correct and I have to pull, I will.
|
|
Top
|
|
|
|
|
#123387 - 09/18/02 08:55 PM
Re: side light
|
Member
Registered: 05/20/02
Posts: 171
Loc: White Mountain Lake, AZ
|
No, you need to find the wire from the underside and turn the plasic retainer and then pull the retainer out. On the top photo (figure 4) it shows how to pull the bulb out from the back. If you need to replace the *entire* light assembly you then need to remove the bumper and UNSCREW the molding from the back side. Do not attempt to pull the molding off, as that will ruin it.
Replacing the bulb should take less than a minute.
Hope that helps,
Larry
_________________________
Larry Carlson www.TCParts.com928-386-0999 TCA #1975
|
|
Top
|
|
|
|
#123388 - 09/18/02 10:15 PM
Re: side light
|
Anonymous
Unregistered
|
I tried it from the underside once, moved the muffler over and still couldn't get my average size hand in there, but I will attempt it again.
thanks
|
|
Top
|
|
|
|
|
|
Previous Topic
Index
