Dodge Truck Handles ?

[30DodgePanel]

Anyone have photos of the original exterior door handles used on 1929-32 DB trucks  ? Measurements would be icing on the cake....

 

Thanks for any help

[ArticiferTom]

I grab some of mine tomorrow .

[ArticiferTom]

This of the non -locking side 4" x1" and the stem which I cut off to attach to my replacement is 3.5" and tapped hole, for inner handle . Shown by machinist rule w/ stop . Discolored one is my original and chromed one is another replacement I picked up . These style have plated brass covers with trim crease . Other I've seen solid without crease, same sized ,but do not know to what they go .  

[30DodgePanel]

Hi Tom, and thanks for the pics..

 

Do you know if those are original to 31/32 ?

I'm trying to determine the differences for those few lost years..

 

I assume this one is for the drivers side since no lock ?

What model is your truck so I can document it ?

 

Thanks for the help

Dave

 

Edited April 2, 2017 by 30DodgePanel (see edit history)

[ArticiferTom]

I believe them to be original as I know it was restored in 90's and where placed back on backwards . Locking handle on driver side ,instead of passenger side and both units rotted with shells split . My truck is Graham / Dodge  built in Oct. 19,1931 so maybe '32 Model UF-10 U2a-109.

 

  Question ,anybody have pic of the inside lock level for the driver side . Goes on a about a 3/16" square that has a tapped hole for holding screw ?

Edited April 3, 2017 by ArticiferTom
add ??? (see edit history)