Jump to content

'53 Skylark horn wire


Guest Jim Farrell

Recommended Posts

Guest Jim Farrell

Steering column is installed. How do I install the horn wire? Once installed, how do I connect it to the horn cable connector, which is the the little rectangular plate with the spring loaded "plunger" on it that has the rest of the horn wire that goes to the horn relay? At the "top" of the horn wire there is a contact and spring. On the engine end of the horn wire is there some type of connector that connects to the spring loaded horn cable connector? I guess the real question is do I have to take the steering column out (or at least loosen it and raise it up) to thread the horn wire down the shaft to the horn cable connector? Thank you 

Link to comment
Share on other sites

Guest Jim Farrell

I think I may have found the answer to my own question in a prior inquiry on this sight from 10/26/15 entitled "54 Skylark steering box removal". There is a referral in one of the answers to that inquiry to "The 54 Buick Highway". On that web sight there is an article on "Buick Power Steering Conversion" by Prof Nailhead that gives detailed instructions on horn wire removal and installation. Since the instructions  primarily are for the 54 Buick, is it safe to assume there are no major differences on the 53 Buick horn wire? Thanks again.    

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...