Jump to content


Photo
- - - - -

67 conti convert rear deck lid issue


  • Please log in to reply
2 replies to this topic

#1 samster1

samster1

    Junior Member

  • Members
  • PipPip
  • 22 posts

Posted 08 October 2012 - 01:06 AM

Hey Guys Back For Help

I had the hydraulics and relays restored in my 67 link conti convert approx 1 year ago...have not had any problems until yesterday..opened deck lid to put roof down and I noticed the top flap was hanging a little low on one side..when it came down it did not seal...I kept trying to lower it and it eventually sealed evenly in the down position..however, when i tried to raise the roof again the deck lid unscrewed and lifted about 4" and then stopped...now its just stuck there can't raise or lower....just hear clicking...now I do have a weak battery..there is a major drain and unless I remember to loosen battery cable battery gets real low..however still enough to turn car over...so not sure its battery related.....hydraulic or relay...how do I get the roof open to get at hydraulics..do I take back seat out and jump relays?

thanks

steve

#2 61polara

61polara

    Senior Member

  • Members
  • PipPipPip
  • 382 posts
  • LocationCharlotte, NC

Posted 25 October 2012 - 11:00 AM

You're at the point where the hydraulic pump should start running. The trip switch may not have made contact because it is out of adjustment. Hold the top switch in the up position and try lifting up on the deck lid and see if the pump starts. If not, it could be a bad pump, relay or switch. Try contacting the person who restored the hydraulics and relays.
Dave

#3 samster1

samster1

    Junior Member

  • Members
  • PipPip
  • 22 posts

Posted 26 October 2012 - 12:56 AM

Thanks Dave
It turned out to be a gear in the lift motor for top panel...Thanks again




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users