Jump to content


Photo
- - - - -

1940 ZEPHYR 292 CU. IN. V-12 CRANK SPECS..???


  • Please log in to reply
4 replies to this topic

#1 LOOKER

LOOKER

    Junior Member

  • Members
  • Pip
  • 2 posts

Posted 07 August 2012 - 11:04 PM

Does anyone out there have crank tolerances (miniumum & maximum) for the 1940 292 CU. IN. V-12 flathead engine..??

I also need the 'housing bore' specs for the big end of the rods.


Would greatly appreciate the help.
Justin

Edited by LOOKER, 07 August 2012 - 11:06 PM.


#2 Mssr. Bwatoe

Mssr. Bwatoe

    Senior Member

  • Members
  • PipPipPip
  • 897 posts

Posted 08 August 2012 - 01:02 PM

1936-1947 Lincoln V12 Service Manual / p49.jpg
get the green v-12 book chk ebay..or look at link above

Attached Thumbnails

  • p49.jpg


#3 LOOKER

LOOKER

    Junior Member

  • Members
  • Pip
  • 2 posts

Posted 08 August 2012 - 04:30 PM

Thanks !!!!! However, bearing/thrust clearances are not my issue... I need the minimum-maximum Crankshaft Specs that I might find in an OLD Clevite book.. I also still need the housing bore spec for the big end of my rods, as well as the mains.

I have a FoMoCo shop manual for this engine already...
Thanks, justin.

#4 Mssr. Bwatoe

Mssr. Bwatoe

    Senior Member

  • Members
  • PipPipPip
  • 897 posts

Posted 08 August 2012 - 09:29 PM

YES THAT WAS A QUICK PAGE..FOR EXAMPLE

Attached Thumbnails

  • p61.jpg


#5 flatcat

flatcat

    Senior Member

  • Members
  • PipPipPip
  • 210 posts

Posted 11 August 2012 - 07:33 PM

36-41 ROD JOURNALS = 2.125-2.1255
36-41 ROD BORE,BIG END = 2.2980-2.2985
36-48 MAIN JOURNALS = 2.4000-2.4005
36-48 MAIN BEARING HOUSING BORE = 2.603-2.604

42-48 ROD JOURNALS = 2.250-2.2505
42-48 ROD BORE BIG END = 2.4222-2.4225

Hope this helps




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users