Seafoam65 Posted January 21, 2015 Share Posted January 21, 2015 I have one tiny ding in my sheetmetal....very hard to see but I'd love to get it out if possible to do paintless dent repair. Is the sheetmetalon a 65 Riv too heavy a gauge for paintless dent removal? Link to comment Share on other sites More sharing options...
64riviera Posted January 21, 2015 Share Posted January 21, 2015 Had two in my '64 Riviera (by my own fault :mad:) and had them removed with paintless dent removal. So it's possible. Link to comment Share on other sites More sharing options...
Seafoam65 Posted January 21, 2015 Author Share Posted January 21, 2015 thanks, that's good news! Link to comment Share on other sites More sharing options...
RivNut Posted January 21, 2015 Share Posted January 21, 2015 Where on the car are the dents in question? Link to comment Share on other sites More sharing options...
Seafoam65 Posted January 22, 2015 Author Share Posted January 22, 2015 Where on the car are the dents in question? The dent is about 2/3 down in the middle of the right door....very small ding...very hard tosee unless you sight down the car while on your knees. Link to comment Share on other sites More sharing options...
64riviera Posted January 22, 2015 Share Posted January 22, 2015 That should be an relatively easy spot to repair. They would go down the door from above and then try to press the dent out. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now