Wanted: Transmission Parts for 1946 Dodge Truck 3 speed

I am searching for the following 3 speed transmission parts for my 1/2 ton Dodge Model WC pickup truck:

575953 (8 pieces)…U-joint cross bushing lock plate

575954 (8 pieces)…U-joint lock plate cover

599741 (1 piece)…Counter shaft gear

579200 (1 piece)…Counter shaft

Anybody have any of these? Contact Van H: krooooooz@gmail.com or 757-286-3382

Hi Van,

I have a complete 3 speed trans from a 41 Plymouth that I would sell cheaply.

What we would need to find out is will it work in your truck?

Any help here??????

Joe

My parts book shows all the parts fit 1941-1947 and for models WC (1/2 Ton) & WD-15 (3/4 Ton).

Hi Van,

I have a complete 3 speed trans from a 41 Plymouth that I would sell cheaply.

What we would need to find out is will it work in your truck?

Any help here??????

Joe

Joe: What condition is the Plymouth transmission in? How much would you want? I wonder if the parts are interchangeable.

Thanks…..Van

Machinist_Bill - thanks for the information

I am usually pretty good at this but I neglected to mention that the 41 Plymouth transmission I have is from a passenger car.

I am not sure if that makes a difference or not. ?????

Van,

Send me an email to - coozie44@yahoo.com - we can correspond through our

email addresses.

I cannot truthfully answer the question about the parts fitting but the transmission I have is in very good condition.

If you send me the part # off of your tranny I can check mine to see if they match or ????

Joe