Jrbrks Posted October 19, 2014 Share Posted October 19, 2014 I have three questions that I do not find covered in the factory service manual for a 1929 Model 135 (Victoria Coupe):1) Can someone please tell me the correct anchor point for the spring on the lever arm of the brake light switch?My switch is working, and the spring is attached to the switch but it is not attached on the other end, and I do not see an obvious anchor point, e.g on the moving shaft for the brake pedal?2) Is there a source for the heavy spring that retracts the brake pedal? Is the brake master cylinder filled from the top by removing the inside carpet and floorboards?3) Can someone tell me where the switch for the back-up light is located, e.g. is it accessed from under the car or from the top of the transmission? Is there a source for a replacement switch should I find my to be faulty?Thank you,Jim Link to comment Share on other sites More sharing options...
Jrbrks Posted October 19, 2014 Author Share Posted October 19, 2014 I have determined the back-up light switch matches the brake light switch (I am slowly figuring out how to find information in the Franklin service and parts manuals).I have not found the location of the back up switch, but I have not yet lifted the floorboards. I have not found the switch from under the car.I should add, that I may have a later transmission in this '29, as my parking brake is by the shifter (in the center of the car) rather than near the driver side door. Thanks for any advice.Jim Link to comment Share on other sites More sharing options...
odat Posted October 21, 2014 Share Posted October 21, 2014 My 29 130 has the brake in the center by the shifter. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now