Guest wacker Posted September 19, 2014 Share Posted September 19, 2014 Hi,Im currently rebuilding my Buick 320 -48 and are thinking about dipping the whole block in acid to get rid of rust and paint.Before doing this I have to remove the camshaft bearings.Will I get into trouble if I try to remove them and then install the same again? I guess they are just pressed into place?While doing this it might be an idea to replace them, Egge got them in their catalogue but Im a bit worried since the workshop manual says they have to be honed to fit. Is that right or will the ones from Egge be the correct size from start?ThanksStefan Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now