Camshaft bearings Buick 320

Hi,

Im currently rebuilding my Buick 320 -48 and are thinking about dipping the whole block in acid to get rid of rust and paint.

Before doing this I have to remove the camshaft bearings.

Will I get into trouble if I try to remove them and then install the same again? I guess they are just pressed into place?

While doing this it might be an idea to replace them, Egge got them in their catalogue but Im a bit worried since the workshop manual says they have to be honed to fit. Is that right or will the ones from Egge be the correct size from start?

Thanks

Stefan