1928 Chevrolet National Series AB Sedan - Trans Parts

I am in need of the following parts for my 1928 Chevy National Series AB Sedan (4cyl)

361964 - Speedometer drive gear with driven gear (my parts list describes it as 4-11 teeth)

343881 - Universal joint assembly

348131 - Universal joint collar retainer including seal (seal part no. - 348259)

I am located in the UK and would appreciate any help in sourcing these parts.

Many thanks.

Anything?

I may have found the joint collar. Still looking for the other parts. New or used.

I think I need the one I have but can look around in our area. There a number of early Chevs. The later 30 and 31 may fit but the cable comes out the other side to clear the exhaust. If you have to use a compensator to adjust the relationship between the rear end and the trans speedo gear they usually are configured in a 90 degree, so that may help.

Thanks. Any help is appreciated.

I have a joint collar on the way.

Still looking for the other parts. Please help if you can.

Still looking for:

speedo drive with driven gear

universal joint assembly

1928 Chevy 4 cyl

There are many early Chevs in Australia. You could try advertising in the Australian Magazine. The address is www.vvcaa.com.au

Bill

Thanks Bill, I will check it out.

Still looking for this: