Foop Posted September 1, 2014 Share Posted September 1, 2014 Anyone know the correct way to install door trim?Clips on body first or clips on the trim first?I searched the forum but could not find specifics.Thanx Foop Link to comment Share on other sites More sharing options...
KDirk Posted September 1, 2014 Share Posted September 1, 2014 Clips on body first. Then "hook" bottom edge of trim over lower edge of clips, followed by using palm of hand to press top edge of trim until it snaps over top edge of clips. If the trim bows out slightly anywhere along it's length, you have one or more clips that are not fully seated in the channel on the rear of the trim. Remember there is an acorn nut on the door trim piece, the short piece on front fender has two acorn nuts and no clips. Rear fender piece has only clips and no nuts.KDirk Link to comment Share on other sites More sharing options...
Foop Posted September 2, 2014 Author Share Posted September 2, 2014 (edited) Makes sense,sounds easy.I found 2 acorn nuts,1 on each end.Thanx Foop Edited September 2, 2014 by Foop (see edit history) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now