Jump to content

38 Ignition switch on column.


Vernsmith

Recommended Posts

Guest 39 Pickup

If it is like the Ford lock, there is a pin that has to be drilled. Drill the center with a 1/8" bit and screw in a slide hammer. When the pin is out the lock cylinder will pull out. May need penetrating oil to help thins along. To replace, drill and tap for a 10-32 set screw to replace the pin.

Link to comment
Share on other sites

If it is like the Ford lock, there is a pin that has to be drilled. Drill the center with a 1/8" bit and screw in a slide hammer. When the pin is out the lock cylinder will pull out. May need penetrating oil to help thins along. To replace, drill and tap for a 10-32 set screw to replace the pin.

Thank you, got lock out Now want to get switch.post-84099-143142702266_thumb.jpgAny ideas? I am afraid of breaking but thought top of shaft was a shimmed not a threaded piece

would you know.

Link to comment
Share on other sites

Thank you, got lock out Now want to get switch.[ATTACH=CONFIG]267633[/ATTACH]Any ideas? I am afraid of breaking but thought top of shaft was a shimmed not a threaded piece

would you know.

If its not froze up why not lube it and put the new cyl in there. The switch has already been removed by looking at the photo.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...