Jump to content

Parts requested: 1934 417W or identical


Stevemo

Recommended Posts

Hi all,

I have put together the first pass on what I will require to get my car back to stock. Please have a look and let me know if you are willing to part with any of these items:

[TABLE=width: 445]

<colgroup><col></colgroup><tbody>[TR]

[TD]

  • Front bumper brackets

[/TD]

[/TR]

[TR]

[TD]

  • Front bumper to bracket fasteners with caps

[/TD]

[/TR]

[TR]

[TD]

  • Gas tank cap

[/TD]

[/TR]

[TR]

[TD]

  • Fuel level sender
  • Dome light lens

[/TD]

[/TR]

[TR]

[TD]

  • Wheel bearing dust caps, front, x2

[/TD]

[/TR]

[TR]

[TD]

  • Rear bumper fastener with cap, passenger side

[/TD]

[/TR]

[TR]

[TD]

  • Tail light lens, left

[/TD]

[/TR]

[TR]

[TD]

  • Tail light, right

[/TD]

[/TR]

[TR]

[TD]

  • Differential access plate

[/TD]

[/TR]

[TR]

[TD]

  • Battery access plate

[/TD]

[/TR]

[TR]

[TD]

  • Spare tire valve stem access cover

[/TD]

[/TR]

[TR]

[TD]

  • Grille verticals or entire grille and frame, etc.

[/TD]

[/TR]

[TR]

[TD]

  • Rear window surround, interior

[/TD]

[/TR]

[TR]

[TD]

  • Door lock levers, interior? not sure how they work. Turns out you lift the door levers up to lock!

[/TD]

[/TR]

[TR]

[TD]

  • Exterior door handle, x1

[/TD]

[/TR]

[TR]

[TD]

  • Rear running board supports, x2

[/TD]

[/TR]

[TR]

[TD]

  • Wheel lug, x1

[/TD]

[/TR]

</tbody>[/TABLE]

I can post photos of what I have and need additional of or where the missing part goes to match things up.

Thanks! Steve

Edited by Stevemo (see edit history)
Link to comment
Share on other sites

Camera died but I got a few photos to start with.

Dome light missing lens, want lens...

post-98704-143142685205_thumb.jpg

Differential access plate:

post-98704-14314268522_thumb.jpg

Battery access plate and missing kick plate that goes across bottom of door opening:

post-98704-143142685239_thumb.jpg

Rear window surround (this one has many rusted out areas)

post-98704-143142685252_thumb.jpg

One interior window crank required and also wondering about door lock levers (the car has an exterior lock, how do you lock the car from the inside???)

post-98704-143142685263_thumb.jpg

Wheel lug, one missing on another axle

post-98704-143142685552_thumb.jpg

Link to comment
Share on other sites

Hopefully I well get a few offers for parts for sale.

Here's the bearing dust cap with the lugs also shown:

post-98704-143142688068_thumb.jpg

Tail end including wrong bumper bolt, missing lens, and missing right side light assembly. I guess I need a license plate holder as well

post-98704-143142688084_thumb.jpg

Front bumper...I don't think this belongs with the car so I need the full deal including the brackets. You can also see the issues with the front grille.

post-98704-143142688097_thumb.jpg

I'm also going to need an interior sun visor, I can only find one with the car.

Thanks again, Steve

Link to comment
Share on other sites

Chances are, your car has the door lock on the passenger side of the car. That was the norm in that era as folks were getting out of their parked cars on the curbside so as to not get run over by a passing vehicle. The correct way to lock the car from the inside with no exterior lock/key is to push the inside handle in the opposite direction that it takes to open the door. That will usually lock that style handle.

The front bumper looks to be from a 1935 or 1936 Ford.

Edited by keiser31 (see edit history)
Link to comment
Share on other sites

  • 3 months later...

Hi Kaiser,

You were right on all counts! Things are progressing with the Parts Hoarding and the list is down to mostly running gear parts.

My main point of focus at this point are the king pins, the front bumper and the license plate holders. The remaining parts can be restored or built by myself if need be...it would just slow me down and drain my pocket book :eek:. It is hard to believe how many NOS parts are floating around in various collections.

post-98704-143142879265_thumb.jpg

Cheers, Steve

post-98704-143142879244_thumb.jpg

Link to comment
Share on other sites

Hi Steve

I have on hand a W front bumper. post-103422-143142880909_thumb.jpg

The bad news is my address.

I can not help you with any other part for Ws

as I am restoring a T and an O. This bumper

was throwed into a container with Hupp Aerodynamic

parts that I received from Australia abt 15 years ago.

Best regards

Olav

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...