Guest Ralf Posted August 13, 2014 Share Posted August 13, 2014 i am looking for some information on how to remove the gearbox on my 1925 B-70.I have removed all attached extenssions and the the transmission case bolts.The gearbox can be pulled back, but only about 1/4 inch.Is it perhaps necessary to remove the clutch housing screws, which bolt the clutch to the flywheel ?.In this case i would have to reinstall the clutch pedal, in order to be able to turn the clutch to reach all the housing screws.I would appreciate any information concerning this problem. Link to comment Share on other sites More sharing options...
nzcarnerd Posted August 13, 2014 Share Posted August 13, 2014 Have you taken the drive shaft out? Link to comment Share on other sites More sharing options...
Guest Ralf Posted August 13, 2014 Share Posted August 13, 2014 drive( propeller) shaft is removed. Link to comment Share on other sites More sharing options...
28 Chrysler Posted August 13, 2014 Share Posted August 13, 2014 Is there rust, dirt or old grease keeping the input shaft from sliding out.You may have to take off the inspection cover on the top of the bell-housing to see what is binding. Link to comment Share on other sites More sharing options...
Guest Ralf Posted August 13, 2014 Share Posted August 13, 2014 inspection cover was removed, without any findings.Transmission was removed 4 years ago by previous owner.Their should be no corrosion related problems.Unfortunatly the previous owner could not be contacted, to give any assistance in how he removed the transmission at this occassion. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now