Guest DANA BIZZELL Posted July 14, 2014 Share Posted July 14, 2014 FIRST TIME USER, WIRED UP LIGHT SWITCH TURN TO RIGHT LIGHTS AND TAIL LIGHTS WORKED, TURN STRAIGHT DOWN OFF, TURN TO LEFT COWL LIGHTS AND TAIL LIGHTS WORKED. INSTALLED NEW BRUSH'S ONE AT A TIME IN PLACE MOVED THIRD BRUSH UP IN DIRECTION OF ENGINE. CRANKED UP AND SHOWED CHARGING, SMOKED WIRES IN SWITCH AND TERMINAL BOX. WHAT CAUSED THE PROBLEM.THANKSDANA Link to comment Share on other sites More sharing options...
Alfa Posted July 14, 2014 Share Posted July 14, 2014 You have a dead short to earth. If you have just recently changed the brushes in the dynamo, it may be that you have inadvertently allowed the wiring connections on the brushes to touch the dynamo casing, causing a short circuit. Check the brushes and also check where you have rewired the switch that there is no short to earth there.I would suggest setting the third brush in the middle of it`s range of adjustment. Too much charge boils the battery and burns away the brushes.Adam.. Link to comment Share on other sites More sharing options...
MCHinson Posted August 7, 2014 Share Posted August 7, 2014 Dana Bizzell,Welcome to the AACA Discussion Forum. I have moved your 2 posts from the CCCA Technical Forum to the General Technical Forum. You may get a few more responses in the correct forum. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now