1937 120 Center Steering Linkage

This topic may have been discussed before in the Forum but I could not find a discussion relating to it.

I have a 1937 120 and need to replace the center steering linkage bearings and pin located under the radiator/engine pully. What is the best way to get at the bearings and pin to remove the old ones and insert the new ones? Does the whole front-end of the car have to come off? Can I just remove the hood, radiator and engine pully?

I would appreciate any help from someone who's been there, done that.

Thanks.

It's too long ago to remember the details but you can do it entirely from below without having to remove the radiator or anything else. You might have a better chance of getting the details if you post on The Packard Club forum (www.packardclub.org) or www.PackardInfo.com.

I will do that Owen_Dyneto. Thanks.