48cabriolet Posted July 24, 2013 Share Posted July 24, 2013 For my 48 connie - my speedo is not functioning - cable is intact as the odometer advances. I have contacted Bob''s speedo in MI for repair - any pointers on how to remove the speedo from the dash panel - looks like very close quarters and could use any tips anyone might have.Thank You! Link to comment Share on other sites More sharing options...
Guest zazothex Posted July 24, 2013 Share Posted July 24, 2013 there are 2-3 clips around the inside edge of the rim that secure it into place. These aren't too bad to get to with a 3" extension on a ratchet. IIRC, it's a 3/8" nut. The bulbs are all press-in, and will come out with a slight lateral push. If they're a bit stuck in and are worried about breaking them, the wires for each are short & lead to a butt connector about 6" back. I had the most difficultly getting it freed from the drive cable, but it's a lot easier once it's hanging out of the dash Link to comment Share on other sites More sharing options...
48cabriolet Posted July 26, 2013 Author Share Posted July 26, 2013 Thank you sir! Link to comment Share on other sites More sharing options...
Guest zazothex Posted July 26, 2013 Share Posted July 26, 2013 hope it helps. I've spent more than a few hours underneath a dash, dodging crap falling in my eyes. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now