Guest raceandoval Posted May 20, 2013 Share Posted May 20, 2013 I'm ready to pull a Flathead Six from a 1949 Windsor with Fluid Drive transmission. Can the engine be pulled separately or does it have to come out as one unit then disassembled? Link to comment Share on other sites More sharing options...
c49er Posted May 22, 2013 Share Posted May 22, 2013 You will need to Pull the M-6 Hi/Lo 2 range trans off the back of the "FluidDrive" bell housing-held on by six bolts and nuts, also remove the driveline, linkages, wires ect. Pull the two rear motor mount bolts and clutch linkage too. The transmission just hangs down too low and will hit the cross member if you try to pull the complete engine assembly with the trans hooked up. The rest of the removal is as any other engine removal.Bob Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now