Jump to content

1940 ZEPHYR 292 CU. IN. V-12 CRANK SPECS..???


Guest LOOKER

Recommended Posts

Guest LOOKER

Does anyone out there have crank tolerances (miniumum & maximum) for the 1940 292 CU. IN. V-12 flathead engine..??

I also need the 'housing bore' specs for the big end of the rods.

Would greatly appreciate the help.

Justin

Edited by LOOKER (see edit history)
Link to comment
Share on other sites

Guest LOOKER

Thanks !!!!! However, bearing/thrust clearances are not my issue... I need the minimum-maximum Crankshaft Specs that I might find in an OLD Clevite book.. I also still need the housing bore spec for the big end of my rods, as well as the mains.

I have a FoMoCo shop manual for this engine already...

Thanks, justin.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...