Guest LOOKER Posted August 7, 2012 Share Posted August 7, 2012 (edited) Does anyone out there have crank tolerances (miniumum & maximum) for the 1940 292 CU. IN. V-12 flathead engine..??I also need the 'housing bore' specs for the big end of the rods.Would greatly appreciate the help.Justin Edited August 7, 2012 by LOOKER (see edit history) Link to comment Share on other sites More sharing options...
Mssr. Bwatoe Posted August 8, 2012 Share Posted August 8, 2012 1936-1947 Lincoln V12 Service Manual / p49.jpgget the green v-12 book chk ebay..or look at link above Link to comment Share on other sites More sharing options...
Guest LOOKER Posted August 8, 2012 Share Posted August 8, 2012 Thanks !!!!! However, bearing/thrust clearances are not my issue... I need the minimum-maximum Crankshaft Specs that I might find in an OLD Clevite book.. I also still need the housing bore spec for the big end of my rods, as well as the mains.I have a FoMoCo shop manual for this engine already...Thanks, justin. Link to comment Share on other sites More sharing options...
Mssr. Bwatoe Posted August 8, 2012 Share Posted August 8, 2012 YES THAT WAS A QUICK PAGE..FOR EXAMPLE Link to comment Share on other sites More sharing options...
Ken/Alabama Posted August 11, 2012 Share Posted August 11, 2012 36-41 ROD JOURNALS = 2.125-2.125536-41 ROD BORE,BIG END = 2.2980-2.298536-48 MAIN JOURNALS = 2.4000-2.400536-48 MAIN BEARING HOUSING BORE = 2.603-2.60442-48 ROD JOURNALS = 2.250-2.250542-48 ROD BORE BIG END = 2.4222-2.4225Hope this helps Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now