Jump to content

'35 Dodge Engine Stuck


Guest Darv Hemann

Recommended Posts

Guest Darv Hemann

I have a'35Dodge 5window coupe, stored inside, with an engine that ran last year, but would turn over, but not start this year. Short version-we replaced most electrical parts, cleaned starter, etc., but last week it would not turn over. No water in the oil, we soaked all cylinders with penetrating oil/diesel fuel, but no luck. The clutch is not stuck to the flywheel, but the flywheel will not move (either way) with a crowbar, even with the starter out. I am now looking for a crank to fit the front of the engine. Any help would be appreciated.

Darv Hemann

Link to comment
Share on other sites

Remove spark plugs & soak down the cylenders with a generous helping of penetrating oil, for starters. Literally drown the cylenders, let it soak for a day or 2 before trying to turn over the engine again. You can use a socket and breaker bar on the nut (bolt head) that holds harmonic balancer. Good luck!

Bob <img src="http://www.aaca.org/ubbthreads/images/graemlins/wink.gif" alt="" /> <img src="http://www.aaca.org/ubbthreads/images/graemlins/wink.gif" alt="" /> <img src="http://www.aaca.org/ubbthreads/images/graemlins/wink.gif" alt="" />

Link to comment
Share on other sites

Guest Darv Hemann

Thanks Bob. We have soaked the cylinders with penetrating oil, and a couple of days later with diesel fuel. We will try the nut also next time.

Darv

Link to comment
Share on other sites

Guest Darv Hemann

Thanks, Harry. I am trying to take your approach because I want to save some labor if possible and I'm not in a hurry. We will continue to soak it and keep trying.

Darv

Link to comment
Share on other sites

Guest imported_Ricky Luke

Darv

I have a similar problem with a '40 C25 Chrysler Royal. You need to soak the valve gear as well. I took the side plates off the engine and tried to see if the valves moved (suggested by an old mechanic). Four are seized at various stages of opening (one fully closed), and will hinder the engine turning over. You can pour diesel or ATF down the inlet manifold, but this doesn't get the exhaust obviously. You may need to remove the head and give them a soak.

Good luck!

Link to comment
Share on other sites

  • 2 months later...
  • 1 year later...

<div class="ubbcode-block"><div class="ubbcode-header">Quote:</div><div class="ubbcode-body">STOP!!!!! If you really care anything about this car you will want to tear the thing down and see why it is stuck. Almost always the exhaust valves are stuck . No amount of ANY penetrant will do a valve job for you ! </div></div>

This guy is RIGHT ON! I have an 36 engine that the valves were rusted in place.

The DPO (Dam Previous Owner) took the soak approuch. After time he forced

the crank by dragging to down the street, witch snapped the cam shaft to

three pieces.

Eric

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...