Otahuhu

Want to purchase Delco Remy 4028 distributor for a 1929 M8 Stutz any condition as long as it is complete internally

Want to buy Delco Remy 4028 model distributor for 1929 M8 Stutz Dont need the cap or rotor

How does one check the timing on a fully assembled in the vehicle Stutz straight 8 motor( M8) that has a single overhead cam dual spark plugs mounted on the side of the head .The only timing mark is on the clutch flywheel and the bell housing hole with has a pointer and is well hidden from view under the firewall and to use a timing light. At TDC at what position should the exhaust cam lob be at vertical or at 45 to the valve ? Appreciate some thoughts on this Regards Len

Would be interested how to check the timing on a Stutz single overhead cam straight eight that the only TDC mark is well hidden under the fire wall There is no exposed pulley on the front of the motor The ignition is dual with two spark plugs per cylinder Is there a way to check this as mentioned in the other articles ? Len

Need to purchase an idle needle and seat for a zenith 105 bronze carburetor This is not a 105D MODEL Refer to attachment Len Harvey

Have a 29 Stutz M8 with an up draft dual throat Zenith which is bronze and believe it is a model 105 not the 105d pot metal . I am in need of the idle control complete unit which has two units for each throat Does anyone have any spares for these carburetors ? Regards Len

Looking at a 1951 Packard 200 model 8 cylinder with the ultramatic transmission How reliable is this transmission ? Is it an easy one to fix? Are there an only issues with this model Packard?

For Sale Used V16 distributor cap Has a small edge broken off where one the spring holding clip onto the cap $us 450.00 plus postage Regards Len

What model of vehicle used a Warner Hi- Flex gearbox cast on its side along with Warner gear Co Muncie Is it off a Stutz Dv32? Len

Appreciate if someone could show the wiring details of the setup for an electric fuel pump as per attached drawing Regards Len

Thank you for the reply .Maybe I was not clear enough. There is no solenoid on the starter motor The foot start when pressed engages a switch on the starter motor by a lever that then engages the Bendix into the fly wheel. No solenoid is involved Regards Len

Could someone list the electrical wiring diagram for an electric fuel pump on a vintage car that is foot started, and uses an oil pressure switch as a safe guard. Some time ago there was one on this site Thanks Len

Thank you for reply on a 105D Zenith I need an idling adjusting needle valve seat number 80 in the list .Are then any parts available for these carburetor? (or rare as hens teeth) Is there a list available for the jet sizes ,venture for this model used on a Stutz? Regards Len

1928 Stutz Zenith updraft Carburetor brass with cast number 105D .Can someone give what the correct float height should be

I have a twin updraft Zenith full brass (105?) that was used to replaced the pot metal original fitted to a 1929 model M Stutz 8 cylinder Does anyone have the specs for the correct jet sizes for this model Zenith for use on a M model , I believe this come off a model BB Stutz Also have a Nos UUR2 Stromberg that has been jet sized using Stromberg data sheets for 1929 Stutz M. However need a longer throttle shaft to pick up the hand throttle does any one makes these? Thanks Len

Gemmer series 215 steering box Is there available a list with the actual complete serial number and the vehicles they were fitted on?The series 215 Gemmer has numbers cast on the side of the box plus more numbers

For Sale 1929 Oldsmobile parts Refer to attached list Regards Len

For Sale 1929/30 Oldsmobile parts Refer to attached list

Here is the start to an Allen motor car an original allen Motometer made especially for the Allen motor company from Columbus. For Sale $US 200.00 plus shipping On some research about Allen cars that came into New Zealand someone contacted me saying they had a motor out of a Allen car Did not follow it up Regards Len

Three early period backing lights complete one has small dent $US 120 plus postage Regards Len

Three early period backing lights complete one has small dent $US 120 plus postage Regards Len

Have two marked Pierce Fog light coloured lenes for sale one has a piece missing on the bottom edge Refer to photo with it mounted into a Dietz bezel (BEZEL NOT FOR SALE) $US120.00 PLUS POSTAGE

Reprint of an early book on pattern building for sheet metal body fabrication for antique style cars $US 80.00 plus postage Regards Len

V16 Marmon used Distributor Cap for sale Has a chip out of were the spring clips fit and still usable Not cracked terminals not arced out $US600.00 plus shipping Contact Len

Six cylinder Remy Distributor Model number 356-C complete Has one of the Terminal cover broken on the cap. Cap can be used . New caps are available. Came off a 1918 Model 37 Oldsmobile Northway motor. These motors used on Oaklands and Scripps Booth contact $US 220.00 plus shipping beaconview8@xtra.co.nz