Jump to content

dangerz

Members
  • Posts

    17
  • Joined

  • Last visited

About dangerz

  • Birthday 11/24/1954

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

dangerz's Achievements

  • Collaborator

Recent Badges

15

Reputation

  1. I plan on ordering in the morning, I appreciate your input ill post pics
  2. A little loud but not to bad it has baffles in it , nice 👍 car its a blast to drive 392 ,4 speed
  3. Thanks for your reply, how tall of U channel, will the rubber show from the outside,, I am using 1/4" glass, how much time do I have with the window urathane before I can't clean it off the glass or do I leave it and wait till it cures and remove it with a razor blade again thanks for your help
  4. So, does anyone know where to get the U shaped weather strip mentioned above
  5. Yes it was a rumble seat car. I didn't get many parts with the car when I bought it I started with empty body no feders or running boards, it was missing the rumble lid and the panel below it . I made those as close as I thought they should look.
  6. I do not have any hardware, sorry I should have mentioned that
  7. The glass is about 3/8ths of an inch lager than the opening. So if I'm understanding the way gm installed the rubber goes around the edges and then a wood frame holds it in place, what would hold the window in place if i were to cut down ? Does someone make rubber that i could put around the window
  8. hello all, I'm installing the glass in my 32 plymouth pb coupe I believe the rear window originally rolled up-and-down but that's not possible now because there's no Room underneath , not sure how to put it in, use urethane and glue it in or how does it install without breaking being up against the metal window opening. How did a fixed window install originally , thanks in advance
  9. Looking for a 32 Plymouth PB crank hole cover and pics of the underside of a rumble lid.
×
×
  • Create New...