bones1931

Was able to purchase a complete kit from the Carburetor Shop. Thanks.

Looking to buy a needle valve and seat for a 1934 Buick 60 Series Club Sedan. Has a Marvel carburetor. 8 cylinder. Mike McDonald mwmcdonald@accesswave.ca

Thanks Mark will check out these sources. Mike

Looking to find a source for parts for the vacuum brakes on our 1934 Buick 60 Series Club Sedan. Any information or help with this would be greatly appreciated.

Looking to purchase rear manifold section for 1934 Buick 60 series. Thanks Mike mwmcdonald@accesswave.ca

You might try Al Lambert Gasket City. alambert@gasketcity.com Great to deal with.

Thanks for the information have sent and e-mail off to see what they can supply. Our rear wheel cylinder is leaking from the bleeder and doesn't tighten up. Not sure what you get in the kit. Thanks Mike

Need help in finding a rear right side brake cylinder for our 1947 International half ton pickup. Thanks Mike

Have a set of 1931 Essex Wire Wheels 19 inch 5 bolt pattern need to find the hubs. Have one front now need another front and two rears. After much searching was able to locate the wire wheels for the 30 Essex Roadster. Any help with this would be appreciated. Thanks Mike mwmcdonald@accesswave.ca

Forgot Picture,

Still looking for Essex Wire Wheel 5 bolt hubs for 1931 Essex 19" wire wheels. Need 1 front and two rears. Have the wire wheels and hubcaps need the hubs. Have located the 6 bolt hubs for the 1930 Essex. See attached photo. Will be in Hershey.

Have two sets of hubcaps for 30 or 31 Essex wire wheels. Can someone tell me which ones are which? The wire wheel opening is about six inches across. Thanks Mike mwmcdonald@accesswave.ca

Dave here is a picture of the 1930 Essex Roadster with the wooden spoke wheels. Mike

David have sent you a private message. You can contact me at mwmcdonald@accesswave.ca Thanks Mike

The standard wheels were wood spoke and the optional were wire. E-mail mwmcdonald@accesswave.ca Thanks Mike