Don Hudd

Thanks Guys, just running out of time, I have the car gone by tomorrow so I have to move fast

thanks for the reply. do I need to take those off, thought there was a connector between interior and exterior for the push rod, the fsm says so but I can't seem to find it

does anyone know how far back the nuts are the seperate the brake push rod. Is it close to the firewall? I can see a hex type nut right when I push the dust boot back about an inch but that doesn't seem to do anything when I turn it. Thanks,

It's white wiyh red interior. Bob I just sold the passenger side mirror

I am in Waterford, mi

I am parting out my 1989 Reatta, Let me know if you need anything. Thanks

The hood will not open when trying the hood release, any options

I am parting out my 1989, all glass is good, and will sell any and all parts. Let me know what you need and will let you know if I have it and if it is any good. best to email me at donaldad12@yahoo.com

Well, after damage to my 1989, and no longer can keep it , I have decided to give up the ghost and part it out. I will post on the parts site, but giving a heads up here. Let me know what you need and will let you know if I have it for sale. I must say, this has been the most helpful and curtious site I have been associated with. Hate to leave, but life goes on. Thank you to all for the help over the years, couldn't have kept the car going as long as I have without you guys.

How do you find a certain person who is a member of the forum? I want to pm someone

Ok , clean the contacts for the wiper switch, washers worked but everything else the same, delaays work as they are supose to but regular works as if on delay and high speed may work, may not. Sometimes when trying the high speed, the wipers act as though you are turning them on and off. So I think I need a new switch. Who sells them?

thanks again, just don't want to break anything

thanks Dave, so the whole thing comes off the switch? It plugs into thing switch not onto it?

Ok I know I'm not the sharpest tool in the shed, I can't figure out how the electrical connector to the wiper switch comes off. I was going to try cleaning the connectors, but I suspect that the switch is bad, my washer does not work now either. I can sometimes get the wipers to go to the park position but only sometimes

is the hvac controler is samething as the programer that is behind the glove box? Where under the hood should I look? Ronnie I will check on the motor for wipers