Hupmobile Discuss Model L Engine Question in the DOMESTIC MAKES & MODELS forums; Well I have finally started on the L engine project. Spent most of the weekend stripping the engine of accessories and getting ready to pull it. But I have hit ...
Model L Engine Question
Well I have finally started on the L engine project. Spent most of the weekend stripping the engine of accessories and getting ready to pull it. But I have hit a roadblock or two....
How do the manifolds come off the car? It appears I remove the exhaust pipe and front 'heat riser' plate from the exhaust manifold. A series of nuts and studs mount the exhaust manifold to the block but this is also bolted to the intake. I see two outer bolts for this but are there two inner ones I do not see also? Then I think I could get to all the intake studs.....
With the exhaust manifold on I cannot get to some of the intake studs and nuts. Correct or am I going about this wrong?
Also, how do I get the lower inside nut off to remove the exhaust pipe? I already twisted off one stud and can't hardly get to this one.
Thanks for all guidance on this-
1963 Stude Avanti
1938 Buick Rdmaster sedan
1931 Ford A cabriolet
1931 Hupmobile L sedan
1916 Hupmobile N roadster
1913 Studebaker SA25 roadster
1912 Overland 59T touring
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Barn Hunter in forum General Discussion
Last Post: February 8th, 2012, 09:07
By popeye31 in forum Technical
Last Post: February 11th, 2010, 18:01
By ACowboy in forum General Discussion
Last Post: January 25th, 2007, 22:11
By Leonard Nettles in forum Oldsmobile - Technical
Last Post: April 26th, 2005, 18:06
By imported_rcawjr in forum Oldsmobile - Technical
Last Post: March 14th, 2005, 16:38