1941 dodge p/u glass install *DELETED*

[tbyrd]

Post deleted by tbyrd

[johnworden1]

The lift mechanism fits into the door through the window opening slot. Be sure to lubricate and check the moving parts for proper operation before fitting it into door. I think there are 3 small screws that secure the machanism and allow for some adjustment. After you get the mechanism in and loosely screwed into place, wind it down to it's lowest point to allow clearance for the glass and channel to fit downward into the interior of the door. I believe the window opening channel has to be removed before the glass can go in. The glass with lift channel attached go into the door also through the window opening slot. You may have to rotate the glass around some in order to get it to fit down into the interior of the door. While a helper holds the glass approx. half way to the fully closed position slowly wind the mechanism up to meet the glass and channel. This meeting of parts should be visible through the opening in the interior side of the door. Connect the lift channel and glass to the mechanism. Fit the window opening channel back in and 3 small rubber bumpers. Wind glass up and down to check its operation and tighten mechanism screws once you achieve free movement up and down. Adjust down stop as needed. John Worden

[tbyrd]

thanks for the info

[dep5]

Why was this post deleted? The question may be useful to someone. Thanks