Results 1 to 4 of 4

Thread: Distributor Timing Device - need info

  1. #1

    Distributor Timing Device - need info

    I have a WASCO timing device but no directions for its use. It is similar to the KRW Timing Fixture, but not quite the same. The WASCO devive was made in Essex Ontario Canada andcan be used on Flat-head Fords 6 and 8 Cyl and LZ 12 Cyl. I need a copy of the instructions.

  2. #2
    Senior Member
    Join Date
    Dec 2007
    Location
    kent, ohio
    Posts
    456

    Re: Distributor Timing Device - need info

    I was going to refer you to the Ford Barn, but see that you were there and found what you needed.

  3. #3

    Re: Distributor Timing Device - need info

    I have not found what I need yet, so I will take your advice and contact the Ford Barn. As a matter of intrest I eed this info to set the timing on my 37 LZ coupe.

  4. #4
    Senior Member
    Join Date
    Dec 2007
    Location
    kent, ohio
    Posts
    456

    Re: Distributor Timing Device - need info

    Quote Originally Posted by Ernie M View Post
    I have not found what I need yet, so I will take your advice and contact the Ford Barn. As a matter of intrest I eed this info to set the timing on my 37 LZ coupe.
    Go to Ford Barn, 32/ 53 section, go to search, type in Wesco Timing instructions, you will find everything you need for that fixture, I didnt specifically look for the V-12 but it should give you enough information to get through it.

    Tom

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need info about "Anti Stall" device
    By stude8 in forum Technical
    Replies: 0
    Last Post: November 4th, 2007, 20:50
  2. 55 Buick nail head Distributor timing
    By oldschoolauto in forum Buick - Post War
    Replies: 3
    Last Post: September 18th, 2007, 18:56
  3. Ignition timing advance springs for 12V NE distributor
    By in forum Dodge & Dodge Brothers
    Replies: 2
    Last Post: February 6th, 2004, 22:24
  4. Replies: 2
    Last Post: August 13th, 2000, 18:34

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •