'56 heater core

[danlb63]

Does anyone know the easiest way to remove and replace a heater core on a '56 special? Does it come out into the fender well? How do you get to the screws or bolts? Do you have to take the fender off?

[imported_NikeAjax]

No you don't have to remove the fender, but that would make it easier; you may be able to gain access by removing the two portholes nearest the door: kinda hard if you have big hands and wrists. It's a big pain in the butt! Feel around the edge of the shroud, you may want to use a wire brish before hand and locate the philips head screws and remove them; use some liquid wrench before hand so not to strip the heads. It takes someone VERY limber as I recall, but it can be done.
I hope this was some help to you; I can look further into it if need be,
Jaybird

[danlb63]

Hey Jaybird, I appreciate the info, I'm sure it will be a pain in the butt as I am both big and old, I've been working on this car 40 years, and it doesnt get any easier but I'll sure give it a try.
thanks, any more info would be appreciated too
Dan Bailey
Las Vegas
danlb63@hotmail.com